Asco 5150 manual

Product Manuals that you may need. Digital Power Meter, Catalog Serial Module, Catalog Acc. All users must follow these precautions:. To avoid possible shock, burns, or d eath, deenergize all electrical. Be sure that Users to whom you give access are t hose persons that you want to. Deta ils on how to configure all required para mete rs for the two modes are in the RA m anuals li sted above.

Encryption disabled mode is the default operation m ode for both the CM and the RA. In this m ode, the TCP port and protocol. See below. Select the appropriate installation pages , that corresponds to the product to be connected. Establish and test communications page Refer to Status LEDs page vii. View and change configuration pages page For RS networks only, before installing the Connectivity Module check the position of the DIP switch actuators on the bottom of the unit. The upper two actuators turn on a built-in termination resistor, if needed.

The lower two actuators select either a 2-wire or 4-wire RS network. See the figure below. Likewise only the farthest device from the Connectivity Module must have the termination resistor ON.

All other devices must be OFF. The DIP switch upper two actuators control the built-in termination resistor:. If a 2-wire RS network is to be attached to the Connectivity Module, move the lower two actuators to the left. If a 4-wire RS network is used, move these actuators to the right. A short serial cable connects the CM to the Controller. Refer to installation drawings provided and follow the steps below to install the Connectivity Module.

Open enclosure door and check with a non-contact AC voltage detector. Mount the DIN rail supplied in the kit onto two studs on the door below the Controller. Connectivity Module will mount on the right side.

A separate power supply is needed unless it is connected to a Power Manager PM. A single communication cable 2 twisted pairs and overall shield connects the CM to the Control Panel. The serial cable from the PM provides the power to the CM.

Mount DIN rail supplied in the kit onto two studs on the door below or adjacent to the Control Panel. Prepare and connect the specified communication cable between the Control Panel terminals and the Connectivity Module J4 terminals as listed below:.

Prepare and connect the 24 Vdc power supply to the Connectivity Module. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. A-5 Communication Address Forms Overview The Connectivity Module brings together several different serial devices that communicate at different baud rates and with different protocols to a common Ethernet media.

Specifications Power Requirements: 24 V dc nominal 8 — 28 V dc 1. Mounting: 35 mm DIN rail Dimensions: 3. Installation Overview 1. OFF — move to right. DIP Switch on bottom of unit. Modbus is a registered trademark of Gould Inc. Serial in.